In this article the potentiality is proven for application of wastepaper sludge ash (WSA) as mineral powder for traditional hot asphalt concrete mix. For the comparative testing in this article the traditional limestone mineral powder is used. The chemical (oxide) composition of the aggregates was studied, while that was determined by means of DRON - 3.0 diffractometer. It was ascertained that CaO is present in wastepaper sludge ash in sufficient quantity, while it provides for utilization of this waste material as an aggregate for asphalt concrete. The limestone mineral powder granulometric composition was determined and the wastepaper sludge ash was grinded by ball grinder till the appropriate granulometric composition was reached. There were studied the main physical and mechanical parameters of bitumen 70/100 to be used for formation of asphalt binder in combination with the studied mineral aggregate. There were formed the following series of traditional hot asphalt concrete mix: on limestone mineral powder, on wastepaper sludge ash, on both limestone mineral powder and wastepaper sludge ash in ratio 50/50, 30/70, 20/80 (% w/w). By means of grading curves of dense-graded continuous mixes there was designed the chip-grain carcass of asphalt concrete mix. The asphalt concrete mix was designed based on the following characteristics: hot fine-grained densegraded asphalt concrete with residual porosity from 2 % to 5 %, with quantity of chip-grains sized more than 5 mm – 35-45 % and the maximum grain-size up to 15 mm. There was determined that WSA can perform as material to be used as mineral powder for asphalt concrete mixes. According to the requirements of Ukrainian standard (DSTU B V.2.7-119:2011), the asphalt concrete with WSA is of standard condition, but the water-saturation index approaches the acceptably allowed value, while in comparison with asphalt concrete with LMP – it is higher by 55%. Such result is due to the difference in oxide composition of the aggregates, namely lower content of products of calcareous rock in WSA. With combined application of limestone mineral powder and WSA in ratio 50/50, 30/70, 20/80 (% w/w) the water-saturation index decreases. As to the compression tensile strength and compression tensile strength after water-saturation, these indices on WSA are lower than on LMP just by 10%. The most efficient usage of WSA, considering the studies done, can be achieved when coupled with LMP in ratio 50/50.
Bajpai P. Management of Pulp and Paper Mill Waste / P. Bajpai. - Switzerland. Springer International Publishing, 2015. - 193 p. https://doi.org/10.1007/978-3-319-11788-1
Frias M., Rodriguez O., Sanchez de Rojas M.I. Рарer sludge, an environmentally sound alternative source of MK - based cementious materials. Contruction and Bulding Materials. 2015 vol. 74, р. 37-48. https://doi.org/10.1016/j.conbuildmat.2014.10.007
Segui P., Aubert J.E., Husson B., Measson M. Characterization of wastepaper sludge ash for its valorization as a component of hydraulic bilders. Applied Clay Science. 2015, vol.57, p.79-85. DOI
Ferreiro S., Frias V., Vigil de la Villa R., Sanchez de Rojas M. The influence of thermo activation of art paper sludge on the technical properties of blended Portland cements. Cem. Concr. Compos., 2013,37,136-142. https://doi.org/10.1016/j.cemconcomp.2012.11.005
Ahmad S. Study of concrete involving use of waste paper sludge ash as partial replacement of cement / S.Ahmad, M. Iqbal Malik, M. Bashir Wani, R. Ahmad // JOSR. J. Eng. - 2013. - Vol. 3, № 11. - Pp. 6-15. https://doi.org/10.9790/3021-031130615
Rahman, M.T.; Mohajerani, A.; Giustozzi, F. Recycling of Waste Materials for Asphalt Concrete and Bitumen: A Review. Materials 2020, 13, 1495. https://doi.org/10.3390/ma13071495
Pasandín, A.R., Pérez, I., Ramírez, A.; Cano, M.M. Moisture damage resistance of hot-mix asphalt made with paper industry wastes as filler. J. Clean. Prod. 2016, 112, 853-862. https://doi.org/10.1016/j.jclepro.2015.06.016
Mohammadinia, A.; Arulrajah, A.; Horpibulsuk, S.; Chinkulkijniwat, A. Effect of fly ash on properties of crushed brick and reclaimed asphalt in pavement base/subbase applications. J. Hazard. Mater. 2017, 321, 547-556. https://doi.org/10.1016/j.jhazmat.2016.09.039
Goncharenko E.G., Dotsenko O.M. Influence of mineral powders on asphalt-polymer binders / Collection of articles «Roads and Bridges», is. 8. - K.: DerzhdorNDI, 2008. P. 68-75. (in Ukrainian).
Goncharenko E.G., Dotsenko O.M. influence of mineral powders on properties polymer asphalt concreteю Collection of articles «Roads and Bridges», is. 5. - K.: DerzhdorNDI, 2006. P. 129-147. (in Ukrainian).
EN 12591:2009 Bitumen and bituminous binders. Specifications for paving grade bitumens.
Bitumens petroleum road viscous. Specifications DSTU 4044: 2019 National Standard of Ukraine. (2019). Kyiv: Ukrarkhbudinform (in Ukrainian)
Mixes asphalt concrete and asphalt concrete road and airfield. Test methods DSTU B V.2.7-319:2016 National Standard of Ukraine. (2016). Kyiv: Ukrarkhbudinform (in Ukrainian)
Mixes asphalt concrete and asphalt concrete road and airfield. Specifications. Change № 1 DSTU B V.2.7-119:2011 National Standard of Ukraine. (2011). Kyiv: Ukrarkhbudinform (in Ukrainian)