гранули

Investigation of Drying Process Kinetics of Composite Granules

Among the large number of modern environmental problems in Ukraine, waste of wastewater treatment stations occupies a special place. During biological water treatment, the separated sludge deposits are sent to the silt fields, which are the biggest problem. Today, these fields reached their capacity three times over and pose a danger, the consequences of which go far beyond environmental problems and have grown into a chain of socio-economic, technical, medical-biological and moral-ethical problems.

PECULIARITIES OF METALLIZATION OF POLYVINYL CHLORIDE GRANULES

The results of experimental studies of copper plating of polyvinyl chloride granules in a chemical precipitation solution are presented. The influence of the surface area of polyvinyl chloride granules on the kinetic regularities of copper reduction and the copper content on metallized granules has been studied. It is established that the surface area of polyvinyl chloride granules has a significant effect on the rate of reduction of copper ions and does not affect the amount of reduced copper.

Activation of polyethylene granules by finely dispersed zinc

The results of experimental researches of features of mechanical activation of polyethylene granules with finely dispersed zinc in a ball mill, and also results of research of chemical copper plating of activated polyethylene granules are given. The influence of the ratio of polyethylene granules and fine zinc, the speed of rotation of the ball mill and the duration of activation, as well as the degree of loading of the components in the activation process of polyethylene granules was studied.

Development and investigation of device for processing polymer materials by 3D-printing method

The analysis of the current state of 3d industry and prospects for its future. In the work, calculations were made and graphs of dependence were obtained, which influence the work of the auger and the installation itself. A new method of printing parts with polymer granules is described and the principle of operation of the equipment used is described. The picture of the working installation with the main components and the method of its attachment on a 3D printer is presented.