твердість

Aim. Analysis of used bits revealed the effect when the tungsten carbide insert cutter was scrolling around its axis. Therefore, the task was to study the causes of this phenomenon. Hardness was measured followed by setting the hardness distribution gradient in the section of the hole, in order to evaluate the strength parameters of steel in the zone of the hole. Method. Applying a well-tested method, namely the method of successive approximations, we determined the estimate of the standard deviation and the evaluation criterion.

One of the main problems of rural residential areas is to provide the local population with quality drinking water, which is a major factor influencing their health. To solve this problem, it is necessary to implement effective measures not only at the state level but also at the regional and local levels. The main purpose of decentralization of power is to transfer the power and appropriate financial resources to the lowest levels of local self-government, which makes it possible for created amalgamated communities to use these resources to solve the priority issues.

This paper reports on usability of activated carbon obtained from areca nut shell, coconut shell, and coconut leaves as a filler to prepare NBR based composite for automobile based application. The carbon was activated by phosphoric acid (H3PO4) as dehydrating agent. The stoichiometric ratio of biomass and phosphoric acid was found to be 3:1 for the batch size of 300 g. As compared to commercially available carbon filler, the activated carbon derived from biomass waste responded better to the petrol swelling test.

The specificities of magneto-abrasive machining of cutting taps made from high-speed steel were researched. Surface roughness after cycle machining of cutting taps on the front surface is reduced to Ra=0,1µm, on the back surface to Ra=0,7—0,9µm, on the cylindrical surface — Ra=0,2— 0,4µm, depending on the conditions of basing the machined pieces during machining, surface hardness increases to 9—10GPa, radii of cutting edge rounded increases on 5–10%. It is shown, that the moment for cutting taps at tapping after MAM on 15–40% less than for unmachined taps.