The aspects of design and operation of information measuring subsystem of Cyber-Physical System of coke and chemical plant are considered. This subsystem of mass parameters definition, based on industrial internet, provides coded remote access aiming at the execution of both weighing and verification metrological operations by using an embedded multivalued mass measure. To ensure the quality and reproducibility of Cyber-Physical System a remote access on the basis of TCP/IP protocol to balances was studied and developed. Installation was equipped with the standard built-in mass measure that enabled to perform in-place operations of metrological checking, verification, calibration etc. not interrupting the production cycle.
[1] NIST Three-Year Programmatic Plan, FY 2014-2016, 2014.
[2] S. Yatsyshyn, B. Stadnyk, Ya. Luysyk, V. Yatsuk. Metrological Array of Cyber-Physical Systems, Part 1. Challenge of Modernity, Sensors & Transducers, Vol. 187, Is. 3, 2015, pp. 1–10.
[3] Strain Gauge Balances for High Load, RUAG Aviation Prospect, Switzerland.
[4] L. Erm, Development of Two-Component Strain-Gauge-Balance Load-Measurement System for the DSTO Water tunnel, DSTOTR-1835, Publ. by Defence Science and Technology Organization, Commonwealth of Australia, 2006.
[5] Industrial Internet Insights Report for 2015, General Electric Company, 2014.
[6] State Standard 3989. Metrology. Calibration of Measuring Instruments, Ukraine, 2000 (in Ukrainian).
[7] Setting and Adjusting Instrument, Calibration Intervals, Agilent Technologies Prospect, 2013.
[8] CSNEN 45501 + AC: Metrological aspects of non-automatic weighing instruments, 1992.