The results of studies of the type influence of treatment and tool material on the structural state of the boundary layer 107WCR5 during treatment are shown. The advantages of turning chisels with composite 10 compared with the process of grinding. Processing treatment with composite 10 in the surface layer for α-and γ-phase is accompanied by compressive residual stresses only, while the abrasive treatment is accompanied by tensile stresses in the kind of I-α- phase structure of high-speed dispensing.
1. Kotlyar D.A. Influence of the type of mechanical treatment on the structure of the surface layers of steel CVM / D.A. Kotlyar, V.S. Antoniuk, Y.A. Fedoran // News of the National Technical University of Ukraine “Kiev Polytechnic Institute .” - Kiev: NTUU “KPI ”. −2011. — № 63. — p. 28-31. 2. Tools made of extrahard materials / under. ed. N.V.Novikov and S.A. Klimenko. — Ed. 2nd rev. and add. -M.: Mechanical Engineering, 2014. — 608. 3. A.V. Kurdiumov Martensitic transformation and diffusion in carbon and boron nitride under shock compression./ A.V. Kurdiumov, V.F. Brytun, N.I. Borimchuk, V.V. Yarosh — K.: Kuprіyanova 2005. — 192. 4. V.I. Buhshteyn. Investigation of the mechanism of wear double-layer plates K10D when processing hardened chromium steel / V.I. Buhshteyn, A.M. Tihontsov, V.M. Volkogon // Superhard materials . — 1989. — № 4. — p.45- 51.