DRYING OF CENOSPHERES RECOVERED BY THE WET-BASED METHOD FROM COAL FLY ASH FOR THEIR RATIONAL USE

EP.
2023;
: сс.271-276
1
Національний університет “Львівська політехніка”
2
Lviv Polytechnic National University
3
Lviv Polytechnic National University
4
Lviv Polytechnic National University

Since slag and coal fly ash (CFA) are major global pollutants produced by thermal power plants (TPPs), special attention should be paid to their rational disposal. Scanning electron microscopy (SEM) was used to study the morphology of CFA and it was suggested that the use potential of CFA is high due to the presence of a large number of cenospheres (CSs), that can be recovered mostly by wet methods for the production of the wide range of products with improved properties. However, such decisions regarding the application of the cenospheres are largely related to the problem of their drying after removal.

The article is devoted to the investigation of the filtration method as less energy-consuming for the drying of cenospheres. The effect of the drying agent velocity on the mass transfer intensity has been established. The values of mass transfer coefficients have been calculated based on the thin-layer experimental data and equation . Calculated mass transfer coefficients for cenospheres have been correlated by the dimensionless expression , based on which equation  has been proposed to calculate the mass transfer coefficients, which is important at the filtration drying equipment design stage.

1. Adesina, A. (2020). Sustainable application of cenospheres in cementitious materials—Overview of performance. Developments in the Built Environment, 4, 100029. doi: https://doi.org/10.1016/j.dibe.2020.100029

https://doi.org/10.1016/j.dibe.2020.100029

2. Arizmendi-Morquecho, A., Chávez-Valdez, A., & Alvarez-Quintana, J. (2012). High temperature thermal barrier coatings from recycled fly ash cenospheres. Applied Thermal Engineering, 48, 117–121. doi: https://doi.org/10.1016/j.applthermaleng.2012.05.004

https://doi.org/10.1016/j.applthermaleng.2012.05.004

3. Badanoiu, A., & Voicu, G. (2011) Influence of raw materials characteristics and processing parameters on the strength of geopolymer cements based on fly ash. Environmental Engineering and Management Journal, 10, 673-681. doi: https://doi.org/10.30638/eemj.2011.091

https://doi.org/10.30638/eemj.2011.091

4. Cheng, T. W., Ueng, T. H., Chen, Y. S., & Chiu, J. P. (2002). Production of glass-ceramic from incinerator fly ash. Ceramics International, 28, 779–783. doi: https://doi.org/10.1016/S0272-8842(02)00043-3

https://doi.org/10.1016/S0272-8842(02)00043-3

5. Dzikuć,M., Kuryło, P., Dudziak, R., Szufa, S., Dzikuć, M., & Godzisz, K. (2020). Selected Aspects of Combustion Optimization of Coal in Power Plants. Energies, 13(9), 2208. doi: https://doi.org/10.3390/en13092208

https://doi.org/10.3390/en13092208

6. Goga, F., Dudric, R., Cormos, C., Imre, F., Bizo, L., & Misca R. (2013). Fly ash from thermal power plant, raw material for glass-ceramic. Environmental Engineering and Management Journal, 12(2), 337-342. doi: https://doi.org/10.30638/eemj.2013.041

https://doi.org/10.30638/eemj.2013.041

7. Goodarzi, F., & Sanei, H. (2009). Plerosphere and its role in reduction of emitted fine fly ash particles from pulverized coal-fired power plants. Fuel, 88, 382–386. doi: https://doi.org/10.1016/j.fuel.2008.08.015

https://doi.org/10.1016/j.fuel.2008.08.015

8. Haustein, E., & Kuryłowicz-Cudowska, A. (2020). The Effect of Fly Ash Microspheres on the Pore Structure of Concrete. Minerals, 10, 58. doi: https://doi.org/10.3390/min10010058

https://doi.org/10.3390/min10010058

9. Hirajima, T., Petrus, H.T.B.M., Oosako, Y., Nonaka, M., Sasaki, K., & Ando, T. (2010). Recovery of cenospheres from coal fly ash using a dry separation process: Separation estimation and potential application. International Journal of Mineral Processing, 95(1-4), 18–24. doi: https://doi.org/10.1016/j.minpro.2010.03.004

https://doi.org/10.1016/j.minpro.2010.03.004

10. Hower, J.C., Groppo, J.G., Joshi, P., Dai, S., & Moecher, D.P. (2013). Location of Cerium in Coal-Combustion Fly Ashes: Implications for Recovery of Lanthanides. Coal Combustion and Gasification Products, 5, 73–78. doi: https://doi.org/10.4177/CCGP-D-13-00007.1

https://doi.org/10.4177/CCGP-D13-00007.1

11. Kindzera, D., Hosovskyi, R., Atamanyuk, V. & Symak, D. (2020). Heat transfer process during drying of grinded biomass in a fixed bed dryer. Chemistry and Chemical Technology, 15(1), 118–124. doi: https://doi.org/10.23939/chcht15.01.118

https://doi.org/10.23939/chcht15.01.118

12. Kosivtsov, Y., Chalov, K., Sulman, M., Lugovoy, Yu., Novichenkova T., Petropavlovskaya, V., Gadzhiev, S., & Popel, O. (2021). Use of Ash and Slag Waste from Thermal Power Plants as an Active Component of Building Materials. Chemical Engineering Transactions, 88, 337-342. doi: https://doi.org/10.3303/CET2188056

13. Mammadov, H., & Gadirov, M. (2018). Application of slags from thermal power station as an effective initial material in the production of artificial porous filler. International Journal of Engineering & Technology, 7(3,14), 461-466. doi: https://doi.org/10.14419/ijet.v7i3.14.17043

https://doi.org/10.14419/ijet.v7i3.14.17043

14. Mitin, I., Kindzera, D., & Atamanyuk, V. (2021). Application of slag from thermal power plant for the production of porous filler. Journal Environmental Problems, 6(2), 110–116. doi: https://doi.org/10.23939/ep2021.02.110

https://doi.org/10.23939/ep2021.02.110

15. Nakonieczny, D., Antonowicz, M., & Paszenda, Z. (2020). Cenospheres and their application advantages in biomedical engineering — A systematic review. Reviews on Advanced Materials Science, 59, 115–130. doi: https://doi.org/10.1515/rams-2020-0011

https://doi.org/10.1515/rams-2020-0011

16. Nithyanandam, A., & Deivarajan, T. (2021). Development of fly ash cenosphere-based composite for thermal insulation application. International Journal of Applied Ceramic Technology, 18, 1825–1831. doi: https://doi.org/10.1111/ijac.13767

https://doi.org/10.1111/ijac.13767

17. Patel, S. K., Majhi, R. K., Satpathy, H. P., & Nayak, A. N. (2019). Durability and microstructural properties of lightweight concrete manufactured with fly ash cenosphere and sintered fly ash aggregate. Construction and Building Materials, 226, 579–590. doi: https://doi.org/10.1016/j.conbuildmat.2019.07.304

https://doi.org/10.1016/j.conbuildmat.2019.07.304

18. Progress (2023). Retrieved from https://www.progress.ua/product/heat-mass-exchange-equipment/filtering-a...

19. Shao, Y., Jia, D., Zhou, Y., & Liu, B. (2008). Novel Method for Fabrication of Silicon Nitride/Silicon Oxynitride Composite Ceramic Foams using Fly Ash Cenosphere as a Pore-Forming Agent. Journal of the American Ceramic Society, 91, 3781–3785. doi: https://doi.org/10.1111/j.1551-2916.2008.02702.x

https://doi.org/10.1111/j.1551-2916.2008.02702.x

20. Strzałkowska, E. (2021). Morphology, chemical and mineralogical composition of magnetic fraction of coal fly ash. International Journal of Coal Geology, 240, 103746. doi: https://doi.org/10.1016/j.coal.2021.103746

https://doi.org/10.1016/j.coal.2021.103746

21. Walker, A., & Wheelock, T.D. (2006). Separation of Carbon from Fly Ash Using Froth Flotation. Coal Preparation, 26, 235–250. doi: https://doi.org/10.1080/07349340601104883

https://doi.org/10.1080/07349340601104883

22. Yadav, V. K., Yadav, K. K., Tirth V., Jangid, A., Gnanamoorthy, G., Choudhary, N., Islam, S., Gupta, N., Son, C. T., & Jeon, B.-H. (2021). Recent Advances in Methods for Recovery of Cenospheres from Fly Ash and Their Emerging Applications in Ceramics, Composites, Polymers and Environmental Cleanup. Crystals, 11, 1067. doi: https://doi.org/10.3390/cryst11091067

https://doi.org/10.3390/cryst11091067

23. Zhuang, X. Y., Chen, L., Komarneni, S., Zhou, C. H., Tong, D. S., Yang, H. M., Yu, W. H., & Wang, H. (2016). Fly ash-based geopolymer: clean production, properties and applications. Journal of Cleaner Production, 125, 253–267, doi: https://doi.org/10.1016/j.jclepro.2016.03.019

https://doi.org/10.1016/j.jclepro.2016.03.019

24. Zyrkowski, M., Neto, R.C., Santos, L.F., & Witkowski, K. (2016). Characterization of fly-ash cenospheres from coal-fired power plant unit. Fuel, 174, 49–53. doi: https://doi.org/10.1016/j.fuel.2016.01.061

https://doi.org/10.1016/j.fuel.2016.01.061