Optimization of Biodiesel Production from Goat Tallow Using Alkaline Catalysts and Combining them with Diesel

2018;
: pp.120-126
1
Department of Chemical Engineering, Bushehr Branch, Islamic Azad University
2
Department of Chemical Engineering, Bushehr Branch, Islamic Azad University

In this research biodiesel is produced from goat tallow in the presence of homogenous catalysts such as KOH and NaOH using trans-esterification process. For this purpose, effect of several parameters such as temperature, reaction time, methanol to oil ratio, type and concentration of a catalyst has been investigated. The results showed that the maximum biodiesel yield (96 and 98 %) was obtained using NaOH and KOH, respectively, and optimal conditions were determined. Also, to improve some properties of biodiesel, biodiesel was mixed with diesel at different ratio (B5-B100) and their properties such as flash point, cloud point, pour point, viscosity and density were measured. It was found that the properties of produced biodiesel is in the range of standard and can be used as a biofuel.

[1] Lee S., Wong Y., Tan Y., Yew S.: Energ. Convers. Manage., 2015, 93, 282. https://doi.org/10.1016/j.enconman.2014.12.067
https://doi.org/10.1016/j.enconman.2014.12.067

[2] Nascimento I., Cabanelas I., dos Santos J., Nascimento M.: Algal Res., 2015, 8, 53. https://doi.org/10.1016/j.algal.2015.01.001
https://doi.org/10.1016/j.algal.2015.01.001

[3] Palash S., Masjuki H., Kalam M., Atabani A.: Energ. Convers. Manage., 2015, 91, 149. https://doi.org/10.1016/j.enconman.2014.12.009
https://doi.org/10.1016/j.enconman.2014.12.009

[4] Xue B.-j., Luo J., Zhang F., Fang Z.: Energy, 2014, 68, 584. https://doi.org/10.1016/j.energy.2014.02.082
https://doi.org/10.1016/j.energy.2014.02.082

[5] Šánek L., Pecha J., Kolomazník K., Bařinová M.: Fuel, 2015, 148, 16. https://doi.org/10.1016/j.fuel.2015.01.084
https://doi.org/10.1016/j.fuel.2015.01.084

[6] Wong P., Wong I., Vong C., Cheung C.: Renew. Energ., 2015, 74, 640. https://doi.org/10.1016/j.renene.2014.08.075
https://doi.org/10.1016/j.renene.2014.08.075

[7] Guldhe A., Singh B., Mutanda T. et al.: Renew. Sust. Energ. Rev., 2015, 41, 1447. https://doi.org/10.1016/j.rser.2014.09.035
https://doi.org/10.1016/j.rser.2014.09.035

[8] Yan B., Zhang Y., Chen G., Shan R.: Energ. Convers. Manage., 2016, 130, 156. https://doi.org/10.1016/j.enconman.2016.10.052
https://doi.org/10.1016/j.enconman.2016.10.052

[9] Yin X., You Q., Ma H., Dai C.: Ultrason. Sonochem., 2015, 23, 53. https://doi.org/10.1016/j.ultsonch.2014.08.020
https://doi.org/10.1016/j.ultsonch.2014.08.020

[10] Tan K., Lee K., Mohamed A.: Energy, 2011, 36, 2085. https://doi.org/10.1016/j.energy.2010.05.003
https://doi.org/10.1016/j.energy.2010.05.003

[11] Esmaeili H., Foroutan R., Asl M.: Advances in Bioresearch 2016, 7, 44. https://doi.org/10.15515/abr.0976-4585.7.1.4452

[12] Zhang F., Fang Z., Wang Y.-T.: Fuel, 2015, 150, 370. https://doi.org/10.1016/j.fuel.2015.02.032
https://doi.org/10.1016/j.fuel.2015.02.032

[13] Charoenchaitrakool M., Thienmethangkoon J.: Fuel Process. Technol., 2011, 92, 112. https://doi.org/10.1016/j.fuproc.2010.09.012
https://doi.org/10.1016/j.fuproc.2010.09.012

[14] Shu Q., Gao J., Nawaz Z., Liao Y.: Appl. Energ., 2010, 87, 2589. https://doi.org/10.1016/j.apenergy.2010.03.024
https://doi.org/10.1016/j.apenergy.2010.03.024

[15] Encinar J., González J., Pardal A.: Fuel Process. Technol., 2012, 103, 9. https://doi.org/10.1016/j.fuproc.2011.12.033
https://doi.org/10.1016/j.fuproc.2011.12.033

[16] Farooq M., Ramli A., Naeem A.: Renew. Energ., 2015, 76, 362. https://doi.org/10.1016/j.renene.2014.11.042
https://doi.org/10.1016/j.renene.2014.11.042

[17] Liu K., Wang R.: Petroleum & Coal, 2013, 55, 68.

[18] Li Y., Qiu F., Yang D. et al.: Biomass Bioenerg., 2011, 35, 2787. https://doi.org/10.1016/j.biombioe.2011.03.009
https://doi.org/10.1016/j.biombioe.2011.03.009

[19] Li Y., Qiu F., Yang D. et al.: Food Bioprod. Process., 2012, 90, 135. https://doi.org/10.1016/j.fbp.2011.02.004
https://doi.org/10.1016/j.fbp.2011.02.004

[20] Chen G., Shan R., Li S., Shi J.: Fuel, 2015, 153, 48. https://doi.org/10.1016/j.fuel.2015.02.109
https://doi.org/10.1016/j.fuel.2015.02.109

[21] Vyas A., Verma J., Subrahmanyam N.: Adv. Chem. Eng. Sci., 2011, 1, 45. https://doi.org/10.4236/aces.2011.12008
https://doi.org/10.4236/aces.2011.12008

[22] Feyzi M., Hassankhani A., Rafiee H.: Energ. Convers. Manage., 2013, 71, 62. https://doi.org/10.1016/j.enconman.2013.03.022
https://doi.org/10.1016/j.enconman.2013.03.022

[23] Altuna Ş., Yaşarb F., Önerc C.: Int. J. Eng. Res. Develop., 2010, 2, 2.

[24] Alptekin E., Canakci M.: Fuel, 2011, 90, 2630. https://doi.org/10.1016/j.fuel.2011.03.042
https://doi.org/10.1016/j.fuel.2011.03.042

[25] Rabu R., Janajreh I., Honnery D.: Energ. Convers. Manage., 2013, 65, 764. https://doi.org/10.1016/j.enconman.2012.02.031
https://doi.org/10.1016/j.enconman.2012.02.031

[26] Saydut A., Duz M., Kaya C.: Biores. Technol., 2008, 99, 6656. https://doi.org/10.1016/j.biortech.2007.11.063
https://doi.org/10.1016/j.biortech.2007.11.063

[27] Diya'uddeen B., Aziz A., Daud W., Chakrabarti M.: Process Saf. Environ., 2012, 90, 164. https://doi.org/10.1016/j.psep.2012.02.005
https://doi.org/10.1016/j.psep.2012.02.005