1. All Authors
  2. Vadym Stupnytskyy

Vadym Stupnytskyy

Department of Robotics and Integrated Mechanical Engineering Technologies, Lviv Polytechnic National University
12 Bandery St., Lviv 79013, Ukraine

Articles published in Academic Journals of Lviv Polytechnic Publishing House

SIMULATION-ANALYTICAL ANALYSIS OF THE INFLUENCE OF TECHNOLOGICAL FACTORS ON THE STRESS-STRAIN BEHAVIOR OF FUNCTIONAL SURFACES OF MOLD PARTS
Vol. 11, No. 1, 2025
Influence of Technological Factors and Cutting Tool Geometry on the Machinability of Chrome-Nickel Steels and Alloys
Volume 58, 2024
ANALYSIS AND DEVELOPMENT OF A CUTTING FORCE MEASUREMENT SYSTEM UNDER PRE-HEATING CONDITIONS OF THE WORKPIECE
Vol. 10, No. 4, 2024
ANALYSIS OF DESIGN AND TECHNOLOGY FEATURES OF INDUSTRIAL SHREDDERS
Vol. 10, No. 4, 2024
INCREASE PRODUCTIVITY OF HARD-TO-MACHINE MATERIALS BY PREVENTIVE HEATING OF THE WORKPIECE
Vol. 10, No. 2, 2024
ANALYSIS OF THERMODYNAMIC, STRESS-STRAIN, AND LOADED STATES OF CHROMIUM-NICKEL ALLOY WORKPIECES USING MACHINING PROCESS SIMULATION IN ADVANTAGE SOFTWARE
Vol. 10, No. 1, 2024
Simulation and analytical studies of chip formation processes in the cutting zone of titanium alloys
Volume 9, Number 1, 2023
Modeling and simulation of machined surface layer microgeometry parameters
Volume 8, Number 1, 2022
Research and simulation of the machining process of difficult-to-cut materials
Volume 6, Number 3-4, 2020
Investigation of the Carbide-tipped Tool Wear Hardened by Method of Aerodynamic Impact
Volume 3, Number 2, 2017
Bahatokryterialna optymizatsiia funktsionalno-oriientovanoho tekhnolohichnoho protsesu mekhanichnoho obroblennia zahartovanykh poverkh[Multi-objective optimization of functionally-oriented technological process of machining hardened surfaces of the molds]
Vol. 50, 2016
Analiz rezultativ imitatsiinoho modeliuvannia shchodo vplyvu temperaturnykh chynnykiv na stan poverkhon v protsesi yikh formoutvorennia [Analysis of simulation results the effect of temperature factors on the condition of the surfaces in forming process]
Vol. 50, 2016
Investigation of the Influence of Machining Factors on the Workpiece Deformation Mode in the Chip-forming Zone by the Finite Element Method
Volume 2, Number 2, 2016
Аналіз та вибір критерію локального руйнування під час імітаційного моделювання процесів різання у системі deform 2D
Volume 729, 2012
Механіка дислокацій під час різання та її моделювання методами скінченних елементів
Volume 729, 2012
Thermodynamic Pattern of the Workpiece Machining by the Rheological Imitation Modelling in Deform-3d System
Volume 772, 2013
Study of Residual Stresses and Deformations by the Ultrasonic Acoustic Strain Measuring Method
Volume 822, 2015
Rheological Model for Physical and Mechanical Properties Surface Layer Formation During Its Cutting
Volume 839, 2016