suspension

The oligomerization in solution and suspension oligomerization of the fraction C9 of liquid by-products of pyrolysis of diesel fuel is initiated by 2- (third-butylperoxymethylamineo) acetate acid have been studied. The nature of the effect of oligomerization, the concentration of the initiator, the temperature and duration of the reaction to the output and the physicochemical characteristics of the obtained oligomers were clarified. The optimal technological parameters of the process of oligomerization of the fraction C9 were selected.

Polyacrylamide and its copolymers are widely used as flocculating agents for the separation of industrial suspensions. The formation of high molecular weight polymers depends on the content of various impurities present in the monomer. The article presents the scientific and practical information on the production of acrylamide by sulfuric acid method of hydration of nitrile acrylic acid in the form of an aqueous solution of different concentrations and a more modern heterogeneously catalytic method of hydration of acrylonitrile using as catalysts with variable valence.

The article investigates vibration and noise protection devices for wheeled vehicles using dynamic vibration absorbers (DVA). Algorithms for modeling their dynamic characteristics based on adaptive calculation schemes are presented. A non-linear suspension with DVA and a noise-absorbing partition is considered, which is due to the introduction of a layered composite thinwalled structure with an intermediate damping layer with high damping properties and a DVA system, which provides better vibration and noise absorption.

The production of a hydrocarbon resins (co-oligomers) by low-temperature dispersion co-oligomerization of C9 fraction of diesel fuel pyrolysis liquid by-products was researched. This method allows to reduce the temperature of the process. The synthesis was carried out by emulsion and suspension co-oligomerization. The main regularities of the suspension and emulsion oligomerization of the hydrocarbon fraction C9 are established. The effect of temperature, initiator concentration and process duration on the yield, physical and chemical properties of synthesized oligomers were investigated.

The article presents the results of experimental studies of the process of intense acceleration, passing through the barrier and the vehicle brakes adapted for the transport of persons using two speed ranges passing through the barrier. Tests were conducted on dry roads made of cobblestones. Performed experimental studies, which aim was to determine the acceleration in each axis while passing through the obstacle.

The paper presents the results of research of the separation of suspensions using flocculants based on polyacrylamide. The mechanism of the floccule formation, as well as polyacrylamide adsorption on the surface of clay particles, depending on the concentration of solids in suspension and flocculant costs are described. An optimal concentration of solids in suspension and flocculant consumption rate which the highest rate of the solid phase deposition is identified. Наведено результати дослідження процесу розділення суспензій з використанням флокулянтів на основі поліакриламіду.

The paper presents the results of research of the separation of suspensions using flocculants based on poly. The essence and process flokuloutvorennya polyacrylamide adsorption on the surface of clay particles, depending on the concentration of solids in suspension and flocculant costs. An optimal concentration of solids in suspension and flocculant consumption at which the highest rate of deposition of solid phase. Наведено результати дослідження процесу розділення суспензій з використанням гідролізованого флокулянта на основі поліакриламіду.

Composite materials based on PbO2 containing TiO2 or ZrO2 were prepared from electrolytes containing a suspension of TiO2 or ZrO2. The contents of foreign oxides in the composite depend on the electrolyte composition and conditions of deposition. When a dispersed phase is incorporated into the composite coating, the dimensions of lead dioxide crystals decrease to submicro- and nano-size. Physico-chemical properties and electrocatalytic activity of composite materials are mainly determined by their chemical composition.